"Power On the Server" on page 157
■
Servicing the Service Processor
The service processor module contains the service processor firmware, IDPROM, and
system battery.
"Remove the Service Processor" on page 124
■
"Install the Service Processor" on page 126
■
Related Information
"Servicing the IDPROM" on page 127
■
"Servicing the Battery" on page 129
■
▼ Remove the Service Processor
Before you begin, complete these tasks:
Read the section,
■
Power off the server using one of the methods described in the section,
■
Off the System" on page
"Extend the Server to the Maintenance Position" on page 70
■
"Disconnect Power Cords From the Server" on page 68
■
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 73
■
"Remove the Top Cover" on page 73
■
Do the following:
1. Ensure that the power cords are disconnected from the server.
2. Loosen the two captive No. 2 Phillips screws securing the service processor to
the motherboard.
124
SPARC Enterprise T5440 Server Service Manual • June 2011
"Safety Information" on page
67.
63.
"Powering