Servicing the DVD-ROM Drive
You must remove the front bezel before servicing the DVD-ROM drive.
"Remove the DVD-ROM Drive" on page 122
■
"Install the DVD-ROM Drive" on page 123
■
Related Information
"Servicing the Front Bezel" on page 119
■
▼ Remove the DVD-ROM Drive
Before you begin, complete these tasks:
Read the section,
■
Power off the server using one of the methods described in the section,
■
Off the System" on page
"Extend the Server to the Maintenance Position" on page 70
■
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 73
■
"Remove the Top Cover" on page 73
■
"Remove the Front Bezel" on page 120
■
Do the following:
1. Remove the flex cable retainer.
Loosen the captive No. 2 Phillips screw and lift the retainer up and out of the
chassis.
2. Unplug the DVD-ROM drive from the flex cable assembly.
3. Push the DVD-ROM drive forward until it protrudes from the front of the
chassis.
122
SPARC Enterprise T5440 Server Service Manual • June 2011
"Safety Information" on page
67.
63.
"Powering