Accessing The Cd-Rw/Dvd-Rw Drive Unit; Removing The Cd-Rw/Dvd-Rw Drive Unit - Fujitsu SPARC Enterprise M5000 Service Manual

6.2.2

Accessing the CD-RW/DVD-RW Drive Unit

●
Power off the server.
This step includes turning the key switch to the Service position, confirming that
the POWER LED is off, and disconnecting power cables. See
"Powering the Server Off Using Software" on page
Caution – There is an electrical hazard if the power cords are not disconnected. All
power cords must be disconnected to completely remove power from the server.
6.2.3

Removing the CD-RW/DVD-RW Drive Unit

Caution – Use proper ESD grounding techniques when handling components. See
Section 1.1, "Safety Precautions" on page
1. Put a No. 1 screwdriver into the CD-RW/DVD-RW drive unit release hole to
release the catch that holds the CD-RW/DVD-RW drive unit in place
(
FIGURE 6-7
2. Remove the drive from the server and place it on the ESD mat.
Removing the CD-RW/DVD-RW Drive Unit
FIGURE 6-7
6-16 SPARC Enterprise M4000/M5000 Servers Service Manual • December 2010
).
4-12.
1-1.
Section 4.4.1,