Installing The M4000 Server Motherboard Unit; Securing The Server - Fujitsu SPARC Enterprise M5000 Service Manual

Caution – The motherboard unit is a long and heavy assembly that houses the
system motherboard on the underside. The motherboard unit is heavy. Two people
are recommended to lift the unit.
4. Remove the motherboard unit from the server.
Be careful not to damage the connectors while removing the unit from the server.
13.1.3

Installing the M4000 Server Motherboard Unit

Caution – The motherboard is heavy. Two people are recommended to lift the unit.
1. Align the motherboard unit and slide it into the rear of the server.
2. Push the motherboard unit handle up to seat the board.
3. Tighten the two (2) captive screws to secure the motherboard unit handle.
4. Pull the system out of the rack.
13.1.4

Securing the Server

1. Install all CPU modules and filler panels.
See
2. Install all memory boards.
See
3. Install the top cover.
This step includes sliding the server in to the equipment rack and restoring the
antitilt features to their original position. See
Cover" on page
4. Tighten the two captive screws that secure the cable management arm to the left
rear of the server.
5. Connect the cable management arm to the equipment rack.
6. Power on the server
This step includes reconnecting power cables, verifying the state of the LEDs, and
turning the keyswitch to the Locked position. See
Server On Using Software" on page
13-6 SPARC Enterprise M4000/M5000 Servers Service Manual • December 2010
Section 12.1.3, "Installing the CPU Module" on page
Section 11.1.3, "Installing the Memory Board" on page
5-8.
12-6.
Section 5.2.2, "Replacing the Top
Section 4.4.2, "Powering the
4-13.
11-6.