Verifying Hardware Operation; Hot Replacement - Fujitsu SPARC Enterprise M5000 Service Manual

2. Type the cfgadm command to confirm the component is now connected.
# cfgadm -a
Ap_Id
Condition
iou#0-pci#0
iou#0-pci#1
iou#0-pci#2
4.2.4

Verifying Hardware Operation

●
Verify the state of the status LEDs.
The POWER LED should be On and the CHECK LED should not be On.
Note – If the hard disk drive is the boot device, the hard disk will have to be
replaced using cold replacement procedures. However, active replacement can be
used if the boot disk can be isolated from the Oracle Solaris OS by disk mirroring
software and other software.
4.3

Hot Replacement

In hot replacement the Oracle Solaris OS does not need to be configured to allow the
component to be replaced. Depending on the FRU to be replaced, the FRU can either
be directly replaced or be inactivated or powered down using an XSCF command.
4-6 SPARC Enterprise M4000/M5000 Servers Service Manual • December 2010
Type Receptacle
etherne/hp connected
fibre/hp connected
pci-pci/hp connected
Occupant
configured ok
configured ok
configured ok