Air Filter Installation For The M4000 Server - Fujitsu SPARC Enterprise M5000 Service Manual

6. Use the showaltitude(8) command to check the setting of air filter.
XSCF> showaltitude
7. Use the rebootxscf(8) command to reset XSCF.
8. Start the domains.
F.2 Air Filter Installation for the M4000
Server
Test fit the filter to the front bezel of the server to make sure you know where it
will attach to the server (
hook and loop tapes make contact. Make sure the bezel is clean and dry before
proceeding.
1. Locate the protective strips on the back side of the filter and clean the bezel in
the same places as the tape (
1000m
Filter is installed.
). Clean the surface of the front bezel where the
FIGURE F-1
).
FIGURE F-2
Appendix F Air Filters F-3