Fujitsu DL9300 User Manual page 60

Button
ONLINE
LOAD
LF/FF
TEAR OFF
PAPER
PATH
MULTI
COPY
FRONT
DIR
MICRO
MICRO
User's Manual
Table 3.1 Buttons Used for Paper Handling
Purpose
Change the Press ONLINE to place the printer online or offline.
printer mode
Stop/resume Press ONLINE to stop or resume printing.
printing
Load/unload Press LOAD to load paper or to retract continuous
paper forms to the "park position."
Save adjusted Press LOAD and ONLINE to permanently store the
load point load position adjusted by micro feeding.
Form feed Press and hold LF/FF to execute a form feed.
Continuous forms are fed forward by one page.
Single sheets are ejected.
Line feed Press LF/FF within three seconds to feed paper
forward by one line.
Advance forms Press TEAR OFF to advance the forms perforation to
for tear-off the tear-off edge. Tear off the forms, then press any
button to retract remaining the forms.
Selects paper Press PAPER PATH to select the paper path: front
path tractor, rear tractor, cut sheet.
Set/reset multi Press MULTI COPY to set or reset multi copy mode.
copy mode
Select cut sheet Select a direction of ejecting cut sheet.
ejection • Front ejection – FRONT indicates
• Rear ejection – FRONT does not indicate
When you save your setting in the setup mode, it
becomes the new default. The default setting is
invoked whenever you turn on the printer.
Micro Feed Press MICRO/ MICRO to feed paper by 1/180
inch in the direction of the arrow.
PAPER HANDLING
Action
3-3