Fujitsu DL9300 User Manual page 31

SETTING UP
2-12
4. Locate the two ribbon release levers on either side of the ribbon
cartridge. Each ribbon release lever has a mounting pin on the
side. Place the mounting pins on the ribbon support bracket of
the print head cartridge. Insert the ribbon so that the ribbon
falls between the nose of the print head and the plastic print
guide.
Head carrier
Print head
Installing the ribbon cartridge
5. Press the ribbon release levers inward until the mounting pins
snap into the holes of the ribbon support brackets. Gently pull
on the cartridge to be sure that the pins are secure in the holes.
6. Turn the ribbon feed knob clockwise to take up any slack in the
ribbon.
7. Close the front cover.
NOTE
A Fujitsu ribbon cartridge is recommended. Don't use other car-
tridges. If other cartridges are used, operating problems or damage
of print head may be caused.
Print guide
Triangle mark
User's Manual