User's Manual
Table 7.1 Print Quality Problems and Solutions (Cont.)
Problem
Printing is
Use the printer's V-ALMNT function to
vertically
check the vertical print alignment. If necessary,
misaligned
adjust the print alignment. See the section
(jagged).
Using the Diagnostic Functions in Chapter 5.
The top margin is The top margin is the sum of the top-of-form
wrong.
setting, the software-specified top margin, and
the printer's TOP-MRG setting. Proceed as
follows:
• Make sure that the top-of-form setting is
correct. The factory default is 25.4 mm (1
inch). See the section Changing Top-of
Form in Chapter 5.
• Check the software-specified top margin.
Refer to your software documentation.
• Check the printer's TOP-MRG setting. See
the section MENU1 and MENU2 Items and
Options in Chapter 5.
Lines are double
Check the line spacing setting in your software.
spaced instead of
single spaced.
Change the CR-CODE setting in the printer
setup mode to CR ONLY. See the section
MENU1 and MENU2 Items and Options in
Chapter 5.
The printer
Change the CR-CODE setting in the printer
overprints on the
setup mode to CR & LF. See the section
same line.
MENU1 and MENU2 Items and Options in
Chapter 5.
The next print line Change the LF-CODE setting in the printer
starts where the
setup mode to LF & CR. See the section
previous line
MENU1 and MENU2 Items and Options in
ended instead of
Chapter 5.
at the left margin.
TROUBLE-SHOOTING
Solution
7-3