Printing A List Of Selected Options - Fujitsu DL9300 User Manual

USING SETUP MODE
PRINTING A LIST OF
SELECTED OPTIONS
SAVE&END MENU1
LIST SELF-TST HEX-DUMP
5-10
The LIST function prints a list of all the printer's currently selected
options. This function is useful for checking the printer settings when
you first enter setup mode or just before you exit. To print a list of
options, load continuous forms paper and then proceed as follows:
1. Enter setup mode.
Press the MICRO button and the MICRO button simultane-
ously until the printer beeps. Wait for the printer to stop
printing and check that the following <<FUNCTION>> menu
is printed:
MENU2 HARDWRE
V-ALMNT
2. Select the LIST function.
Repeatedly press the " " or " " button to position the red
cursor on LIST. Next press the " " button or the " " button to
select the LIST function. The printer starts to print a list of the
currently selected options. The preselected factory settings,
also called factory defaults, are shown on the opposite page.
When the printer finishes printing the list of options, it reprints
the <<FUNCTION>> menu.
3. Do either of the following:
• Select another function, or
• Exit setup mode, saving any changes you made.
For details about other functions, see the other sections in this
chapter. To exit setup mode and save your changes, make sure
that the red cursor is positioned on SAVE & END, then press
the MICRO button or the MICRO button.
<<FUNCTION>>
ADJUST CONFIG DEFAULT
GAP-ADJ
User's Manual