USING SETUP MODE
5-36
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items Options
<TEARPOS>
The following <TEAR-EN> item is printed when TEAROFF:AUTO
is specified for the <TEAROFF> item.
<TEAR-EN>
0 sec
1 sec
2 sec
4 sec
6 sec
Description
Note: For both settings, tearoff
positioning will fail if the page
length setting does not match the
actual perforation spacing.
Tearoff enabled time (offset time).
The offset time is from when data
transfer stops to when the printer
performs automatic tearoff feed.
If the printer receives data again
within the offset time, the printer does
not perform automatic tearoff feed.
In some application programs, data
transfer may stop temporarily due
to internal processing. This setting
can avoid an undesired tearoff feed by
waiting for up to six seconds each
time data transfer stops.
User's Manual