NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual page 68

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
3. Enter the settings as explained in
Table 3-1. VLAN Profile Settings
Setting
VLAN Profile
Profile Name
VLAN ID
Port Membership
Port 1
Port 2
Port 3
Port 4 / DMZ
IP Setup
IP Address
Subnet Mask
DHCP
Disable DHCP
Server
3-8
Table 3-1.
Description (or Subfield and Description)
Enter a unique name for the VLAN profile.
Note: You can also change the profile name of the default VLAN.
Enter a unique ID number for the VLAN profile. No two VLANs can have the
same VLAN ID number.
Note: You can enter VLAN IDs from 2 to 4093. VLAN ID 1 is reserved for the
default VLAN; VLAN ID 4094 is reserved for the DMZ interface.
Select one, several, or all port check boxes to make the ports members of this
VLAN.
Note: A port that is defined as a member of a VLAN profile can send and receive
data frames that are tagged with the VLAN ID.
Enter the IP address of the VPN firewall (the factory default is 192.168.1.1).
Note: Always make sure that the LAN port IP address and DMZ port IP address
are in different subnets.
Note: If you change the LAN IP address of the VLAN while being connected
through the browser to the VLAN, you will be disconnected. You must then open
a new connection to the new IP address and log in again. For example, if you
change the default IP address 192.168.1.1 to 10.0.0.1, you must now enter
https://10.0.0.1 in your browser to reconnect to the Web Management Interface.
Enter the IP subnet mask. The subnet mask specifies the network number portion
of an IP address. Based on the IP address that you assign, the VPN firewall
automatically calculates the subnet mask. Unless you are implementing
subnetting, use 255.255.255.0 as the subnet mask (computed by the VPN
firewall).
If another device on your network is the DHCP server for the VLAN, or if you will
manually configure the network settings of all of your computers, select the
Disable DHCP Server radio button to disable the DHCP server. This is the
default setting.
v1.0, April 2010
LAN Configuration