Lan Or Wan Port Leds Not On; Troubleshooting The Web Management Interface - NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall Reference Manual
Gigabit quad wan ssl vpn firewall
Hide thumbs
Also See for SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall:
- Configuration manual (8 pages) ,
- Use manual (9 pages) ,
- Network setup manual (8 pages)
Table of Contents
Advertisement
LAN or WAN Port LEDs Not On
If either the LAN LEDs or WAN LEDs do not light when the Ethernet connection is made, check
the following:
•
Make sure that the Ethernet cable connections are secure at the VPN firewall and at the hub,
router, or workstation.
•
Make sure that power is turned on to the connected hub, router, or workstation.
•
Be sure you are using the correct cables:
When connecting the VPN firewall's WAN ports to one or two devices that provide the
Internet connections, use the cables that are supplied with the devices. These cables could be a
standard straight-through Ethernet cables or an Ethernet crossover cables.
Troubleshooting the Web Management Interface
If you are unable to access the VPN firewall's Web Management Interface from a PC on your local
network, check the following:
•
Check the Ethernet connection between the PC and the VPN firewall as described in the
previous section
("LAN or WAN Port LEDs Not
•
Make sure your PC's IP address is on the same subnet as the VPN firewall. If you are using the
recommended addressing scheme, your PC's address should be in the range of 192.168.1.2 to
192.168.1.254.
Note: If your PC's IP address is shown as 169.254.x.x:
Windows and Mac operating systems generate and assign an IP address if the
computer cannot reach a DHCP server. These auto-generated addresses are in
the range of 169.254.x.x. If your IP address is in this range, check the
connection from the PC to the VPN firewall and reboot your PC.
•
If your VPN firewall's IP address has been changed and you do not know the current IP
address, reset the VPN firewall's configuration to factory defaults. This sets the VPN
firewall's IP address to 192.168.1.1. This procedure is explained in
Configuration and Password" on page
Troubleshooting and Using Online Support
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
10-8.
v1.0, April 2010
On").
"Restoring the Default
10-3
Advertisement
Table of Contents
Troubleshooting
