Release Lever - Epson Stylus Photo 2100 / 2200 Service Manual

EPSON Stylus PHOTO 2100/2200

1.2.5 Release Lever

On this printer, set the Release lever as indicated in the following table depending on
the used paper type.
Table 1-9. Release lever Setting
Paper Release lever Position
Cut sheet, OHP, Label,
Front side position
Roll paper
Envelope, Board paper First step from front position
Second step from front
*a
CD-R tray
- Far side position
*a : When the CD-R tray is loaded, any position other than the second
step from the front position will result in a release lever error.
*b : The far side position of the Release lever is used when placing
thick paper (board paper) or CD-R tray. After placing thick paper
or CD-R tray, move the release lever to the appropriate position.
PRODUCTION DESCRIPTION
Gap Correction
0mm
+1.3mm
+2.7mm
position
*b
-
<Front side position>
<Second step from front position>
Figure 1-12. Release Lever Positions
Basic Specifications
Revision A
<First step from front position>
<Far side position>
25