Epson Stylus Photo 2100 / 2200 Service Manual page 71

EPSON Stylus PHOTO 2100/2200
Printer Condition
Power
Release Lever Error - High speed Blink
Paper Out Error -
"-" : don't care
Blink : 0.5sec on + 0.5sec off repetition
Blink 2 : 0.2sec on + 0.2sec on + 0.2sec on 0.4sec off repetition
TROUBLESHOOTING
Table 3-1. Error Indications and Fault Occurrence Causes
Indicators
Paper Ink 1-7
-
On -
Error Indications and Fault Occurrence Causes
EPSON Printer Window 3
High speed Blink : 0.1sec on + 0.1sec off repetition
Blink alternately 1 : 0.5sec on + 0.5sec off repetition
Blink alternately 2 : 0.5sec on + 0.5sec on repetition
Fault Occurrence Cause
This error is detected in the following case.
The Release lever is in the release position, or when the
CD-R tray is not fitted (Only for Stylus PHOTO 2100),
in the CD-R printing position.
This error is detected in any of the following cases.
1. The paper is not set to the right Edge guide.
2. The PE sensor cannot detect the lower end of the
paper in paper feeding operation.
3. When the CD-R tray was fitted, the CD-R was not
detected and the Tray was ejected.
(Only for Stylus PHOTO 2100)
4. The CD-R tray home position was not detected
properly and the Tray was ejected.
(Only for Stylus PHOTO 2100)
Revision A
71