Epson Stylus Photo 2100 / 2200 Service Manual page 97

EPSON Stylus PHOTO 2100/2200
Occurrence Timing Phenomenon Detail
At power-on The power-on sequence is
executed but Fatal error is
displayed.
At power-on, the PF motor does
not operate at all.
TROUBLESHOOTING
Table 3-17. Phenomenon-Based Fatal Error Check Points
Faulty Part/Part
Name
PF drive system 1. Check B9<H> of the EEPROM to confirm that 79 is at 6C<H>.
PF motor 1. Check that the PF motor connector cable is connected to CN16
on the Main board correctly.
PF motor
2. Using a tester, check that the resistance of the PF motor is
23.0Ω ± 25%.
3. Check the PF motor connector cable for damage.
Troubleshooting
Check Point
Revision A
Remedy
1. If the value is as in Check point 2, change the
PF motor for a new one.
1. Connect the PF motor connector cable to
CN16 on the Main board correctly.
2. If the resistance value is abnormal, change the
PF motor for a new one.
3. Change the PF motor for a new one.
97