Epson Stylus Photo 2100 / 2200 Service Manual page 79

EPSON Stylus PHOTO 2100/2200
Occurrence Timing Phenomenon Detail
At power-on The printer does not operate at all.
TROUBLESHOOTING
Table 3-3. "Phenomenon-Based Communication Error Check Points"
Faulty Part/
Part Name
Panel FFC 1. Check that the Panel FFC is connected to the connector of the
Panel board correctly.
Panel board
2. Check the Panel FFC for damage.
Panel board 1. Check the Panel board for damage.
Power supply 1. Check that the connector cable of the Power supply board is
board connected to CN15 on the Main board.
2. Check that the blue-lined pin of the Power supply board
connector cable is inserted into the 1 pin side.
(Refer to the above photo.)
Troubleshooting
Check Point
Panel FFC
Blue line
CN15
Revision A
Remedy
1. Connect the Panel FFC to the connector of the
Panel board correctly.
2. Change the Panel FFC for a new one.
1. Change the Panel board for a new one.
1. Connect the connector cable of the Power
supply board to CN15 on the Main board.
2. Connect the Power supply board connector
cable with the blue-lined side placed on the 1
pin side.
79