Epson Stylus Photo 2100 / 2200 Service Manual page 123

EPSON Stylus PHOTO 2100/2200
4.2.1.2 Removing the Rear Housing
1. Remove the three screws 2) C.B.S 3
Housing.
Rear Housing
Figure 4-7. Screws That Secure the Rear Housing
2. Lower the Release Lever in advance. While pulling down the three cutouts, which
secure the bottom of the Rear Housing as seen from the printer rear, one by one,
release them from the Rear Housing. Push the two hooks, which secure the left and
right, one by one toward the printer inside to pull them out of the Lower Housing,
and remove the Rear Housing from the printer using the two upper hooks as
supports.
DISASSEMBLY AND ASSEMBLY
×
10 (9±1kgf.cm) that secure the Rear
Hooks
C.B.S 3×10
Fully take care when releasing the three lower cutouts since they
whiten easily.
Especially as the cutout on the bottom left side as viewed from the
printer rear whitens more easily than the others. The
recommended disassembling procedures are as follows.
Remove the right side hook figured on 2 in the Figure4-8 by
pushing the blue circuled portion strongly. Then remove the
right bottom (red circuled portion on 2 in the Figure4-8.
Then, remove the right side of the Rear housing and remove
the center bottom cutout carefully.
After that, while pulling the Rear housing downward, remove
the left side hook figured on 1 in the Figure4-8 by pushing the
blue circuled portion strongly. By pulling the Rear housing
downward, the left bottom cutout portion is easily released
fron the bottom housing.
Hook
Printer bottom
Cutouts
Figure 4-8. Hooks and Cutouts That Secure the Rear Housing
Disassembly
Revision A
2
1
3 4
Hook
123