Epson Stylus Photo 2100 / 2200 Service Manual page 82

EPSON Stylus PHOTO 2100/2200
Occurrence Timing Phenomenon Detail
At power-on At power-on, the Paper guide of
the Printer mechanism is open
and Release lever error is
displayed.
The Release lever is in the front
position and the Paper guide is
closed but Release lever error is
displayed.
TROUBLESHOOTING
Table 3-4. Phenomenon-Based Release Lever Error Check Points
Faulty Part/
Part Name
Release lever 1. Check that the Release lever is not in the far position, or when the
CD-R tray is not fitted (Only for Stylus PHOTO 2100), is not in
the CD-R printing position.
2. Check that the Release lever is not in other than the CD-R
printing position when the CD-R tray is fitted.
(Only for Stylus PHOTO 2100)
Release lever 1. Check that the Release lever sensor connector cable is connected
sensor to the Release lever sensor and Main board (CN1) securely.
Release lever sensor
2. Move the Release lever sensor detection lever manually in the
same state as when the Release lever makes contact with the
Detection lever, and check that the Detection lever returns to the
original position automatically when released.
3. Using a tester, check that the Release lever sensor is normal.
• Connector (CN1)
Open
Not open
Troubleshooting
Check Point
: 3.3V
: 0V
Revision A
Remedy
1. Move the Release lever to the front or thick
paper printing position.
2. Move the Release lever to the CD-R printing
position.
(Only for Stylus PHOTO 2100)
1. Connect the Release lever sensor connector
cable to the Release lever sensor and Main
board (CN1) securely.
2. Change the Release lever sensor for a new one.
3. Change the Release lever sensor for a new one.
82