Epson Stylus Photo 2100 / 2200 Service Manual page 205

EPSON Stylus PHOTO 2100/2200
3. Before moving the Adjust lever, remove the Ink cartridges, loosen the two screws
that secure the I/C spring and Head fastener, and remove the Torsion spring on the
left of the CR.
Torsion spring
left fixing screw
Figure 5-17. Head Fastener Fixing Screws and Torsion Spring
4. Refer to Figure 5-16 and move the Adjust lever, and while pressing both ends of
the Head fastener against the far side of the CR, tighten the fixing screws.
Figure 5-18. Head Fastener Fixing Method
5. Fit the Ink cartridges, print the Head tilt adjustment pattern, and check the
adjustment result.
ADJUSTMENT
I/C spring
Head fastener Head fastener
right fixing screw
6. Execute Steps 1 to 5 until the black and light magenta rules are at uniform
intervals.
When moving the Head angular adjust lever again after checking
the adjustment result, always remove the Ink cartridges, loosen
the Head fastener fixing screws, and then move the Adjust lever.
Adjustments
Revision A
205