Epson Stylus Photo 2100 / 2200 Service Manual page 72

EPSON Stylus PHOTO 2100/2200
Printer Condition
Power
Paper Jam Error -
Paper Gap Error -
"-" : don't care
Blink : 0.5sec on + 0.5sec off repetition
Blink 2 : 0.2sec on + 0.2sec on + 0.2sec on 0.4sec off repetition
TROUBLESHOOTING
Table 3-1. Error Indications and Fault Occurrence Causes
Indicators
Paper Ink 1-7
Blink -
On -
Error Indications and Fault Occurrence Causes
EPSON Printer Window 3
High speed Blink : 0.1sec on + 0.1sec off repetition
Blink alternately 1 : 0.5sec on + 0.5sec off repetition
Blink alternately 2 : 0.5sec on + 0.5sec on repetition
Fault Occurrence Cause
This error is detected when the paper remaining near the
PE sensor cannot be ejected in the paper loading
sequence, or if the paper near the PE sensor cannot be
ejected with the FF command or Paper switch.
This error is detected if the printer judges that the
Carriage made contact with the paper, which was fed
from the Paper guide manual (Board paper feeding port),
at the time of paper width detection.
Revision A
72