Epson Stylus Photo 2100 / 2200 Service Manual page 221

EPSON Stylus PHOTO 2100/2200
Table 6-2. Lubrication Points
Ref.
Lubrication Type/Point
No.
<Lubrication Point>
Holes of right parallelism adjust bush and sub-
right parallelism adjust bush
<Lubrication Type>
22
G-26
<Lubrication Amount>
Entire periphery of inside diameter
<Lubrication Point>
Portions where both sides of the CR guide shaft B
make contact with the Slider CR
<Lubrication Type>
G-56
<Lubrication Amount>
1) φ3mm x 30mm: CR guide shaft B left side
2) φ3mm x 30mm: CR guide shaft B right side
23
Never lubricate the CR guide shaft A directly. Doing so will give
critical faults to the main components of the printer.
Never apply an excessive amount of oil to the oil pad. Doing so
will give critical faults to the main components of the printer.
MAINTENANCE
Remarks
Apply grease to the entire
periphery.
Refer to Figure 6-20.
Refer to Figure 6-21.
Place the Adjust lever in
the front side position,
move the Carriage unit
to the center, and apply
grease from both ends
of the Carriage unit to
between both ends of
the Housing upper
fixing frame.
Place the Release lever
in the far side position,
move the left end of the
Carriage unit from the
left end of the Housing
upper fixing frame to a
+/- 30mm position, and
apply grease.
Overview
G-26
Figure 6-3. Lubrication Point 1
G-26
G-26
G-26
Figure 6-4. Lubrication Point 2
Revision A
Right side
221