Fitting The Protective Materials - Epson Stylus Photo 2100 / 2200 Service Manual

EPSON Stylus PHOTO 2100/2200

4.2.19 Fitting the Protective Materials

This section describes how to fit the protective materials that are needed when
returning the printer to the user.
1. Fit a protective material between the I/C Cover and Carriage Unit, and apply a
blue tape from the Carriage Unit to the I/C Cover and to the right side (as seen
from the printer front) of the Upper Housing to fix the Carriage Unit.
Figure 4-147. Fixing the Carriage Unit
2. Insert protective materials into the first and third stages of the Stacker and also
insert a protective material into between the Stacker and Middle Housing.
Protective material
Figure 4-148. Fixing the Stacker
DISASSEMBLY AND ASSEMBLY
Blue tape
Protective
materials
3. Apply blue tapes to two areas of the Upper Housing and Stacker to fix them.
Figure 4-149. Fixing the Upper Housing and Stacker
4. Apply blue tapes to the left and right of the Rear Housing and Middle Housing to
fix them.
Blue tape
Figure 4-150. Fixing the Rear Housing and Middle Housing
Disassembly
Revision A
Blue tapes
186