Epson Stylus Photo 2100 / 2200 Service Manual page 176

EPSON Stylus PHOTO 2100/2200
Place the two Compression Springs 0.65, which are located on
the lower side of the Rear Paper Guide as seen from the printer
rear, into the recesses of the Under Frame, and reinstall the Rear
Paper Guide.
Refer to Figure 4-126, "Positions of the Compression Springs
0.65".
Compression Springs 0.65
Figure 4-126. Positions of the Compression Springs 0.65
Securely fitted into the joggles on the left and right lower sides of
the Rear Paper Guide, the Compression Springs 0.65 are
designed to be difficult to come off. If they have come off,
however, securely insert them into the joggles on the lower side
of the Rear Paper Guide.
Refer to Figure 4-126, "Positions of the Compression Springs
0.65".
When removing and reinstalling the Rear Paper Guide, also be
fully careful not to peel off the coating of the PF Roller.
Refer to Figure 4-123, "Removing the Front Paper Guide".
5. In order not to bring the Driven Roller and PF Roller surface into contact with
each other, place the Release Lever in the far position.
DISASSEMBLY AND ASSEMBLY
6. Remove the Extension Spring 9.65 from the PF Roller Support.
Hook
Extension Spring
9.65
Figure 4-127. Removing the Extension Spring 9.65
7. Remove the Grounding Spring that engages the PF Roller and Rear Frame.
8. Release the joggle of the Bush 12 from the Left Frame, and after turning it to the
front as seen from the printer front, slide the PF Roller to the left.
Bush 12
Figure 4-128. Removing the PF Roller
Disassembly
Revision A
Under Driven
Roller
PF Roller
Support Lever
Joggle
Grounding Spring
PF Roller
176