Epson Stylus Photo 2100 / 2200 Service Manual page 153

EPSON Stylus PHOTO 2100/2200
6. Pull the CR Linear Scale toward the left side of the Carriage Unit as seen from the
printer front.
Pulling the CR Linear Scale from the right side of the Carriage
Unit may damage the Extension Spring 1.494. Therefore, always
remove the Spring 1.494 first, then remove the right end of the CR
Linear Scale, and pull the CR Linear Scale from the left side of the
Carriage Unit.
Refer to Figure 4-72, "Removing the CR Linear Scale".
When reinstalling the CR Linear Scale, do not twist the leg of the
Extension Spring 1.494.
Refer to Figure 4-72, "Removing the CR Linear Scale".
Reinstall the CR Linear Scale with the cut portion of its left end
facing upward as viewed from the printer front. (To install its
front and rear sides precisely)
Refer to Figure 4-72, "Removing the CR Linear Scale".
7. Pull the FFC from the Connector of the CR Encoder Sensor Board on the back of
the Carriage Unit.
FFC
Encoder Sensor
Board
Figure 4-73. Removing the FFC
DISASSEMBLY AND ASSEMBLY
Hook
Disassembly
When reinstalling the Carriage Unit, connect the FFC to the
Encoder Sensor Board in advance, then fit the Carriage Guide
Shaft A to the Carriage Unit and fix the Carriage Unit to the
Printer Mechanism. If you attempt to fit the FFC after reinstalling
the Carriage Unit and Carriage Guide Shaft A as in the reversal of
the disassembly procedure, the FFC cannot be connected correctly
or may be damaged.
Refer to Figure 4-73, "Removing the FFC".
Before connecting the FFC to the CR Encoder Sensor Board, hitch
it on the hook of the Carriage Unit.
Refer to Figure 4-73, "Removing the FFC".
8. Loosen the one screw 6) C.B.S 3
Stopper Holder.
Printer Mechanism rear left side
Compressi
on Spring
Driven
24.5
Pulley
Stopper
Holder
C.B.S 3×6
Figure 4-74. Releasing the Driven Pulley Stopper Holder
When reinstalling the Driven Pulley Stopper Holder, provide a
clearance by inserting a 0.3mm thickness gauge between the
Driven Pulley Holder and Driven Pulley Stopper Holder.
Refer to Figure 4-74, "Releasing the Driven Pulley Stopper
Holder".
Revision A
×
6 (6±1kgf.cm) that secures the Driven Pulley
Thickness
Thickness gauge spec.
0.3mm
gauge
153