System Settings; Auto Reset; Power Saver Time - Fuji Xerox DocuPrint P355 d User Manual

• Adobe Protocol
Purpose:
To specify PostScript communication protocol. You can configure the Adobe Protocol settings for the wired
network. The change becomes effective after the printer is turned off and then on again.
Values:
Auto
Standard
BCP
TBCP*
Binary

System Settings

Use System Settings to configure a variety of printer features.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.

• Power Saver Time

Purpose:
To specify the time for transition to Power Saver mode.
Values:
Low Power 1min
Timer
1–60 min
Sleep Timer 1min
1–60 min
Select 1min (default) for Low Power Timer if your printer shares an electrical circuit with your room lights and you
notice them flickering. Otherwise, select a high value to keep your printer available for frequent use with the
minimum warm-up time.
The printer automatically returns to the standby mode from the Power Saver mode when it receives data from the
computer. You can also change the status of the printer to the standby mode by pressing the
button on the operator panel.

• Auto Reset

Purpose:
To automatically reset the settings to the default settings and return to the standby mode after you do not specify any
settings for the specified time.
Values:
*
45sec
1min
2min
3min
4min
Sets the PostScript communications protocol automatically.
Sets the PostScript communications protocol to Standard.
Sets the PostScript communications protocol to BCP.
Sets the PostScript communications protocol to TBCP.
Sets the PostScript communications protocol to Binary.
*
Specifies the time taken by the printer to enter Low Power mode after
it finishes a job.
*
Specifies the time taken by the printer to enter Sleep mode after it has
entered Low Power mode.
Using the Operator Panel Menus
(Energy Saver)
165