Avaya 3641 Installation, Configuration And Administration page 99

Message Description
DO NOT END The Wireless IP Telephone is in a critical
section of the software update.
Duplicate Addr/# Gatekeeper rejected registration request from
the Wireless IP Telephone.
Duplicate IP The Wireless IP Telephone has detected
another device with its same IP address.
Erase Failed Download process failed to erase the memory
in the Wireless IP Telephone.
Erasing Memory Wireless IP Telephone has determined that a
download should occur and is erasing the
current software from memory. This message
also displays a progress bar. When the
progress bar fills the display line the erase
operation is complete.
Error!... A fatal software error is detected. All handset
operation is halted and any call is lost.
Extension Error Displayed for 5 seconds when all of the
Communication Managers contacted indicate
that they do not recognize the current
extension as valid.
Extension in Use The phone is trying to register with an
extension that is already registered on the
Communication Manager.
Files Too Big Wireless IP Telephone software download files
are incorrect or corrupted.
Flash Config Error Wireless IP Telephone internal configuration is
corrupt.
Gatekeeper REJ Gatekeeper rejected Discovery Request from
the Wireless IP Telephone.
H225 Listen Fail Wireless IP Telephone cannot communicate
with the AP or the AVPP.
Wireless IP Telephone Status Messages
Action
None. Do not remove the Battery Pack or
attempt to END the handset while this is
displayed. Doing so may require the handset
to be returned to Avaya to be recovered.
Check the H.323 gatekeeper configuration in
the Wireless IP Telephone.
Verify the gatekeeper or PBX's configuration.
Verify the handset has been assigned the
correct extension and that no other H.323
devices share that extension.
If using DHCP, check that the DHCP server is
properly configured to avoid duplicate
addresses.
If using Static IP, check that the Wireless IP
Telephone was assigned a unique address.
Operation will retry but may eventually
report the error "int. error: 0F" Power cycle
the handset.
None. When the progress bar fills the display
line the erase operation is complete.
Do not turn the Wireless IP Telephone off
during this operation.
This message appears during Halt on Error
mode. An error message displays. Note the
message details and power cycle the
handset.
The user will be asked to enter a valid
extension and password.
See Avaya Communication Manager
Integration Factors section.
Download new software from the Avaya site
per Software Maintenance.
Perform "Restore Defaults" operation via
administrator menus [or reprogram with
Configuration Cradle].
Check the H.323 gatekeeper configuration in
the Wireless IP Telephone.
Verify the gatekeeper or PBX's configuration.
This message may display with another
diagnostic message. Follow diagnostic
actions for the second message (such as No
Net Found).
Issue 1, January 2007 99