Configuring The Avaya Voice Priority Processor; Connecting To The Avaya Voice Priority Processor - Avaya 3641 Installation, Configuration And Administration

Part A: Avaya Voice Priority Processor
3.

Configuring the Avaya Voice Priority Processor

During initial setup of the Avaya Voice Priority Processor the IP address is established and
the maximum number of active calls per access point is set. Optionally, you may enter a
hostname and a location for software updates via TFTP.
3.1

Connecting to the Avaya Voice Priority Processor

The initial connection to the Avaya Voice Priority Processor must be made via a serial
connection to establish the Avaya Voice Priority Processor's IP address. After the IP
address is established, connection to the Avaya Voice Priority Processor may be done via
the network using telnet. It is recommended that the basic setup actions occur while the
serial connection is made.
Connect via the Serial Port
1. Using a DB-9 female, null-modem cable, connect the Avaya Voice Priority Processor
to the serial port of a terminal or PC.
2. Run a terminal emulation program (such as HyperTerminal™) or use a VT-100
terminal with the following configuration –
Bits per second – 9600
Data bits – 8
Parity – None
Stop bits – 1
Flow control – None
3. Press Enter to display the Avaya Voice Priority Processor login screen.
4. Enter the default login – admin and default password – admin. These are case
sensitive.
5. The NetLink SVP-II System menu will display.
Connecting Via Telnet
Telnet can only be used after the Avaya Voice Priority Processor's IP address is
configured.
The telnet method of connection is used for routine maintenance of the NetLink Server for
both local and remote administration, depending on your network.
To connect via telnet, run a telnet session to the IP address of the Avaya Voice Priority
Processor. Once you connect and log in, the NetLink SVP-II System menu displays.
18 Avaya Voice Priority Processor, Avaya 3641/3645 Wireless IP Telephone, Handset Administration Tool