Avaya 3641 Installation, Configuration And Administration page 51

your wired network. To configure Cisco FSR in your Avaya 3641/3645 Wireless IP
Telephone, you must enter a Radius Server username and password into each handset.
Username
– Enter a username that matches an entry on your Radius server.
Usernames are alphanumeric strings, and can be entered using the alphanumeric
string entry technique.
Password
– Enter the password that corresponds to this Username.
Consult the Configuration Note for the access points (APs) installed in your
facility for information on which of the WPA versions are recommended by Avaya
engineering. Configure the recommended version on the AP and select the
corresponding option on the Admin menu.
Regulatory Domain/802.11 Config/Transmit Power
Regulatory domain, 802.11 configuration and transmit power are interdependent settings.
Once the domain and 802.11 type are established, the transmit power may be set.
The 802.11 option(s) and the transmit power option(s) must be set to match the
corresponding settings used by the APs in your facility.
FCC requirements dictate that the menu for changing the regulatory domain be available
by password, which in our case is the LINE key. To set the domain, press LINE and then
select the domain.
01 - North America
02 - Europe
Once the regulatory domain is established, the 802.11 Config modes are displayed. Only
one may be chosen. 802.11(b & b/g mixed) is the default. If 802.11(a) is selected,
another menu opens so that you can select 802.11a transmission frequency range(s).
Only those ranges which are allowed in the selected domain are displayed. Multiple ranges
may be selected. Selected mode and ranges are marked with an asterisk (*). Press the
Done softkey when you are finished specifying the 802.11 mode.
The Transmit Power menu opens when the Done softkey is pressed. Only those power levels
which apply to the domain and 802.11 mode are listed. Only one level may be selected.
The default will vary with the domain and 802.11 mode. The selected level is marked with
an asterisk (*). Note that the bands labeled DFS may vary depending on the selected
regulatory domain.
Diagnostics
Run Site Survey
The Site Survey mode is activated by selecting this option. Site survey starts running
immediately upon selecting this option. See the Diagnostic Tools section for more
information about site survey.
Diagnostics [Disable/Enable]
See the Diagnostic Tools section for a detailed explanation of the Diagnostics option.
Syslog Mode
See the Diagnostic Tools section for a detailed explanation of the syslog mode options.
Avaya 3641/3645 Wireless IP Telephone Configuration
Issue 1, January 2007 51