Avaya 3641 Installation, Configuration And Administration page 101

Message Description
No Call Server IP The Wireless IP Telephone cannot obtain an IP
address for an Avaya Communication
Manager.
No DHCP Server Wireless IP Telephone is unable to contact the
DHCP server.
No SSID Attempted to run site survey application
without an SSID set.
No Extension All Wireless IP Telephones require an Extension
for H.323.
No Func Code Wireless IP Telephone software download files
are incorrect or corrupted.
No Gatekeeper The Wireless IP Telephone has not received a
response from the gatekeeper.
No Gatekeeper IP The Wireless IP Telephone is configured for
static IP addresses and no valid unicast IP
address is assigned for gatekeeper
configuration.
No Gateway IP The Wireless IP Telephone is configured for
static IP addresses and no valid unicast IP
address is assigned for gateway configuration.
No Host IP (Addr) The Wireless IP Telephone is configured for
"static IP" (as opposed to "use DHCP") and no
valid host IP address (the Wireless IP
Telephone's IP address) has been entered.
No IP Address Invalid IP.
No Net Access Cannot authenticate / associate with AP.
No Net Found Wireless IP Telephone cannot find any APs.
No APs This indicates any of the following:
No radio link.
No SSID – Incorrect SSID.
AP does not support appropriate data rates.
Wireless IP Telephone Status Messages
Action
Assure that the Wireless IP Telephone is
administered properly for its environment.
Refer to the section on Wireless IP Telephone
Configuration and Communication Manager
Integration Factors for details on
configuring the Wireless IP Telephone.
Check that DNCP is operational and
connected to WLAN or use Static IP
configuration in the Wireless IP Telephone.
Let Wireless IP Telephone come completely
up.
Statically configure an SSID in the Admin
menu.
Enter a valid Extension in the configuration
settings.
Reconfigure the handset to gain access to
the WLAN and download new code.
Verify that the gatekeeper is running and
has network connectivity to WLAN
infrastructure.
Configure a valid IP address in Admin
menus.
Configure a valid IP address in Admin
menus.
Enter a valid IP address in the configuration
settings or change to "use DHCP".
Check the IP address of the Wireless IP
Telephone and re-configure if required.
Verify the AP configuration.
Verify that all the WEP settings in the
Wireless IP Telephone match those in the
APs.
Verify that the AP is turned on.
Verify the SSID of the wireless LAN and
enter.
Check the AP configuration against
configuration document for AP.
Issue 1, January 2007 101