Avaya 3641 Installation, Configuration And Administration page 102

Part D: Appendix
Message Description
Out of range.
Incorrect security settings
No Net Found x...x – AP MAC address.
xxxxxxxxxxxx yy yy – AP signal strength.
Wireless IP Telephone cannot find a suitable
access point; displays MAC and signal
strength of "best" non-suitable AP found.
No Reg Domain Regulatory Domain not set.
No SVP IP The Wireless IP Telephone is configured for
"static IP" (as opposed to "use DHCP") and no
valid AVPP address has been entered.
No SVP Response y...y – AVPP IP address.
yyy.yyy.yyy.yyy
Wireless IP Telephone has lost contact with the
AVPP.
No SVP Server Wireless IP Telephone can't locate AVPP.
AVPP is not working.
No LAN connection at the AVPP.
No SVP Server Wireless IP Telephone unable to perform DNS
No DNS Entry lookup for AVPP, server had no entry for AVPP.
No SVP Server Wireless IP Telephone is unable to perform DNS
No DNS IP lookup for AVPP, no IP address for DNS server.
No SW Found A required software component has not been
identified.
Not Installed! A required software component is missing.
102 Avaya Voice Priority Processor, Avaya 3641/3645 Wireless IP Telephone, Handset Administration Tool
Action
Try getting closer to an AP. Check to see if
other Wireless IP Telephones are working
within the same range of an AP. If so, check
the SSID of this Wireless IP Telephone.
Verify that all the Security settings in the
Wireless IP Telephone match those in the
APs.
Check AP and handset network settings
such as SSID, Security, Reg domain and Tx
power.
Ensure APs are configured per Configuration
Note.
Try Site Survey mode to determine more
specific cause.
Configure the Regulatory Domain of the
Wireless IP Telephone.
Enter a valid AVPP IP address in the
configuration setting or change to "use
DHCP."
This may be caused by bad radio reception
or a problem with the AVPP. The Wireless IP
Telephone will keep trying to fix the problem
for 20 seconds, and the message may clear
by itself. If it does not, the Wireless IP
Telephone will restart. Report this problem
to the system administrator if it keeps
happening.
IP address configuration of AVPP is wrong or
missing.
Check error status screen on AVPP.
Verify AVPP connection to LAN.
The network administrator must verify that a
proper IP address has been entered for the
AVPP DHCP option.
The network administrator must verify
proper DHCP server operation.
Check that the Wireless IP Telephone license
type has a corresponding entry in the
slnk_cfg.cfg file.
Check that the pd14ccc.bin and pi1400.bin
entries exist in under this license type in the
slnk.cfg.cfg file.
Check that all required software files are on
the TFTP server, if over-the-air downloading
is being used. If the error repeats, contact
Avaya Technical Support.