Avaya 3641 Installation, Configuration And Administration page 100

Part D: Appendix
Message Description
H245 Listen fail Wireless IP Telephone cannot communicate
with the AP or the AVPP.
Incompatible The switch is rejecting the software version
presented by the phone.
Initializing ... The Wireless IP Telephone is performing START
initialization.
Internal Err. # # The Wireless IP Telephone has detected a fault
from which it cannot recover.
OE – Error while writing the Flash (return
Wireless IP Telephone to factory).
OF – No functional code (contact Avaya
Technical Support).
Invalid Revision Gatekeeper rejected registration request from
the Wireless IP Telephone.
Multiple GW Reg y...y – Gateway IP address.
yyy.yyy.yyy.yyy Wireless IP Telephone received responses from
multiple gateways; displays IP address of one
responding gateway.
Multiple SVP Reg y...y – AVPP IP address.
yyy.yyy.yyy.yyy Wireless IP Telephone received responses from
multiple AVPPs; displays IP address of one
responding AVPP.
Must Upgrade SW! Wireless IP Telephone software is incompatible
with hardware.
Net Busy x...x – AP MAC address.
xxxxxxxxxxxx Wireless IP Telephone cannot obtain sufficient
bandwidth to support a call; displays MAC of
failing AP.
No Answer Called party did not answer the Wireless IP
Telephone.
No Call Server This indicates that while a Communication
Manager has responded to the Gatekeeper
(The No Call Server
Request message, it is not responding to the
message may include an
Registration Request message.
error indication)
100 Avaya Voice Priority Processor, Avaya 3641/3645 Wireless IP Telephone, Handset Administration Tool
Action
This message may display with another
diagnostic message. Follow diagnostic
actions for the second message (such as No
Net Found).
If this condition persists, contact the Avaya
system administrator.
None. This is informational only.
Record the error code so it can be reported.
Turn the Wireless IP Telephone off then on
again.
If error persists, try registering a different
Wireless IP Telephone to this telephone port.
If error still persists, contact Avaya
Technical Support and report the error.
Verify the gatekeeper or PBX's configuration.
Ensure the gatekeeper and PBX will support
version 2 of the H.323 protocol.
Check each NetLink Telephony Gateway for
the Wireless IP Telephone's MAC address on
the Telephone Line Configuration screen.
Delete any duplicate entries, leaving only
one entry on the correct Telephone Gateway
and port for this Wireless IP Telephone.
This can happen if the Wireless IP Telephone
has been re-configured to use a different
AVPP and then powered-up before the
previous server has had time to determine
that the Wireless IP Telephone is no longer
connected to it. The problem should go
away after about 30 seconds.
Download new software from the Avaya site
per Software Maintenance.
Try the call again later.
No action. Not an error.
Check that the Wireless IP Telephone is
contacting the correct Communication
Manager, and that the Communication
Manager is correctly configured for the
extension in question.