Fostex VM200 User Manual page 190

VM200 & MIDI
Manual transmission of Bulk Dump Messages
Press the
[MIDI]
1.
The VM200 displays the 6:BULK DUMP function page.
Press the
[ENTER]
2.
The VM200 starts transmitting Bulk Dump Data to the connected
MIDI device and displays the following message:
"WARNING! Transmit Bulk Dump Data Now..."
Warning: Do not power off the VM200 while it is transmitting data or
you may damage the system or the connected MIDI device.
Specifying the data you want to transfer
Press the
[MIDI]
1.
The VM200 displays the 6: BULK DUMP function page.
Rotate the EQ/LO GAIN rotary control to adjust the Item
2.
parameter.
This parameter specifies the data you want the VM200 to trans-
fer.
Rotate the EQ/LO-MID GAIN rotary control to adjust the
3.
Block parameter.
This parameter specifies the block of data you want the VM200 to
transfer. The Block parameter is available only if you select
SETUP, SCENE, EFF LIB, or EQ LIB for the Item parameter.
Rotate the EQ/HI-MID GAIN rotary control to adjust the
4.
Interval parameter.
The Interval parameter specifies the interval between data blocks
during Bulk Dump transmission.
Item
ALL (default)
SETUP
SCENE
EFF LIB
190
key six times (from start of cycle).
key.
key six times (from start of cycle).
Contents
All items listed in this table
VM200 all current setup data
Scene memories
Effect library user programs
Block
N/A
ALL, SYSTEM, MIDI, LOC MEM
ALL, CURRENT, 00–99
ALL, 50–99
VM200 User's Guide