Fostex VM200 User Manual page 102

Monitoring Signals
PFL: In PFL (Pre-Fader Listen) mode, the VM200 feeds a soloed
channel's pre-fader signal to the Solo buss and then outputs it
only to the MONITOR OUT and PHONES.
Pressing the appropriate
master or Rec Buss signal before it is adjusted by the Master
Fader or Rec Buss Gain parameter.
You can use this mode to monitor individual input signals during
a recording session to make isolated EQ adjustments or to ensure
that the signals are not clipping.
You can solo input channels that are turned off (i.e., that have
their keys turned off).
[ON]
M-Solo: In Mix-Solo mode, the VM200 feeds a soloed channel to
the stereo buss, and then outputs it to the ST BUSS OUT, MONI-
TOR OUT, and PHONES. You can solo only channels that are
routed to the Stereo Buss.
The VM200 mutes all channels except the channel you select to
solo. (However, you can use a Solo Safe function in this mode. For
more information, see "Solo Safe Function" on page 104.)
In this mode, Master and Rec Buss
You can use this mode to adjust individual channels during mix-
down.
Rotate the channel 7/8 (EQ/HI) Gain rotary control to select
5.
a Solo Key mode.
EQ/LO
GAIN
FREQ
PAN
SOLO KEY PARAMETER OPTIONS
LATCH
UNLATCH
Press the
6. [CHANNEL/METER]
The VM200 exits Setup mode and displays the CHANNEL EDIT func-
tion page.
102
[SOLO]
EQ/LO-MID
GAIN
Q FREQ Q
PAN PAN PAN
In Latch mode, when you press a [SOLO] key, it remains
depressed, and the channel continues to solo until you
press the key again . This is the default setting.
In Unlatch mode, when you press and hold a [SOLO] key, it
remains depressed, and the channel continues to solo
until you release the key .
or
key enables you to solo the stereo
keys are disabled.
[SOLO]
EQ/HI-MID
GAIN
FREQ FREQ
Q
PAN PAN PAN
key.
[EXIT]
EQ/HI
GAIN
Q
PAN
VM200 User's Guide