Fostex VM200 User Manual page 145

REVERB-CHORUS (47)
Parameter
REV TIME
PRE DLY
HI RATIO
PRESENCE
DENSITY
LPF
CHO DEPTH 0–100 [%] (1 step)
CHO BAL
1. Brightness increases with a positive setting, and decreases with a negative setting.
2. With AUTO, the optimum value for the REV TIME setting will be used.
FLANGE-REVERB (48)
Parameter
FLA RATE
DEPTH
FLA FB
REV TIME
PRE DLY
HI RATIO
PRESENCE
DENSITY
LPF
REV BAL
1. Brightness increases with a positive setting, and decreases with a negative setting.
2. With AUTO, the optimum value for the REV TIME setting will be used.
VM200 User's Guide
Value
0.1–30.0 [s] (0.1 step)
0–160 [ms] (1 step)
0.1–1.0 (0.1 step)
1
-10–0–+10 (1 step)
2
0–10, AUTO
1.00kHz–20.2kHz, THRU
(step: same as EQ)
0–100 [%] (1 step)
Value
0.01–2.00 [Hz] (00.1 step)
0–100 [%] (1 step)
0–100 [%] (1 step)
0.1–30.0 [s] (0.1 step)
0–160 [ms] (1 step)
0.1–1.0 (0.1 step)
1
-10–0–+10 (1 step)
2
0–10, AUTO
1.00kHz–20.2kHz, THRU
(step: same as EQ)
0–100 [%] (1 step)
Description
Length of the reverberation.
Delay time from the early reflections until the
reverb.
Length of the high frequency reverberation,
expressed as a ratio relative to REV.TIME.
Brightness in the high range of the reverb.
Density of the reverb.
Cut-off frequency of the low pass filter.
Modulation depth.
Level of chorus sound.
Description
Modulation speed. (0.01 step when ENTER is
pressed.)
Modulation depth.
Feedback amount.
Length of the reverberation.
Delay time from the early reflections until the
reverb.
Length of the high frequency reverberation,
expressed as a ratio relative to REV.TIME.
Brightness in the high range of the reverb.
Density of the reverb.
Cut-off frequency of the low pass filter.
Level of reverb sound.
Effects Parameters
145