Fostex VM200 User Manual page 104

Monitoring Signals
Solo Safe Function
The VM200 features a Solo Safe function that enables you to desig-
nate specific channels as "solo safe."
You can monitor solo safe channel signals that are sent to the stereo
buss regardless of the channel's
available when Solo Mode is set to M-Solo (see page 98).
Press the Setup
1.
The VM200 displays the SETUP:SYSTEM 4:SOLO SAFE function page. All
keys flash.
[EQ EDIT]
Select the desired channel layer using the
2.
[9–16 ADAT IN]
the
[EQ EDIT]
The
[EQ EDIT]
keys of the non-solo safe channels continue to flash.
EDIT]
The boxes of the solo safe channels are highlighted (dark) on the
display.
In the example above, channels 5 & 6 are designated as "solo
safe" channels. In this case, pressing the channel 1
M-Solo mode will enable you to monitor not only the channel 1
signal, but also the channels 5 & 6 signals from the stereo buss.
Other channels will be muted.
Press the
3. [EXIT]
Channel Edit mode.
104
[SOLO]
key four times (from start of cycle).
[SYSTEM]
, and
[17–20 EFF RTN]
key of the target channels.
keys of the solo safe channels light up, the
key or the
[CHANNEL/METER]
key status. This function is
[1–8 ANALOG IN]
Page Select keys and press
[SOLO]
key to return to
,
[EQ
key in
VM200 User's Guide