Fostex VM200 User Manual page 178

VM200 & MIDI
Control Change Messages
You can send Control Change messages to the VM200 to control
VM200 parameters in real time. (For more information, see "Using
Control Change Messages" on page 184.)
Inversely, when you adjust parameters on the VM200, the VM200 can
transmit Control Change messages to remotely control the parame-
ters of connected MIDI devices or instruments.
Control Change TX
Turn on the Control Change TX parameter if you want the VM200 to
transmit Control Change messages when you adjust mix parameters.
The default setting is "Off."
Control Change RX
Turn on the Control Change RX parameter if you want the VM200 to
adjust mix parameters when a Control Change message is received.
The default setting is "Off."
Control Change Table
The Control Change Tables assign Control Change numbers to vari-
ous controller numbers.
These assignments enable you to send MIDI messages from an exter-
nal MIDI device to control VM200 parameters in real time.
For example, you could assign Control Change number 5 to channel
fader 5. If you then send Control Change number 5 from a connected
device to the VM200, the VM200 will adjust fader 5.
The VM200 features two Control Change Tables (01 User Table, and
02 Preset Table). You can use the Control Change Table parameter to
select Table 01 or 02.
The default setting is "01."
For more information, refer to the "Control Change To Control
Parameters Assignment Tables" on page 211.
178 VM200 User's Guide