Activating Edit Mode - AMX G3 Firmware Instruction Manual

Designing Touch Panel Pages
General Button Categories (Cont.)
Status buttons (read-only)
Operation bars
Touch to Continue buttons
Joystick buttons
Bargraph buttons

Activating Edit Mode

Before designing touch panel pages and buttons, you must activate Edit mode on the panel (via the
Setup page). Once activated, use the
and configure touch panels, pages, and buttons. When powering up the touch panel, (by default) the
first page is the Main page (FIG. 1). Note that the Edit button is not available initially. If you have a
pre-programmed panel, you may not see the Main page.
FIG. 1 Main page
To activate the Edit mode:
1. Press
6
in the Main page to open the Setup page (FIG. 2).
SETUP
Status buttons always have a dark fill with light letters and only
display panel information.
Operation bars appear in the place of the Editor bar, after selecting a
button or page edit operation. The operation bar indicates which edit
function is currently active. When an edit operation is selected, it
remains active until you press EXIT.
"Touch to Continue" buttons appear when an operation requires user
acknowledgement.
Joysticks are vertical and horizontal direction controllers for use with
pan and tilt camera controllers.
Bargraph buttons display a dynamic bargraph (vertical or horizontal).
An example is the Battery level indicator button.
button to enter Edit mode. This mode has options to add
EDIT
G3 Firmware Design and Reference