Brightness Button Types - AMX G3 Firmware Instruction Manual

Editor and Setup Reference

Brightness button types

This feature sets the button to open the color palette and brightness controls. Select BRIGHTNESS
from the Button Type menu to set the selected button to Brightness. The button type BRIGHTNESS
and associated options appear in the Button Properties page.
This sets the button to open the Brightness page shown in FIG. 29. This page displays the
Brightness, Contrast, and/or the Color palette.Press the UP and DN buttons to set the LCD
brightness and contrast on the touch panels.
FIG. 29 Brightness page
The
TRANSPARENT
black, white, and transparent buttons in the place of the above displayed page. The AXB-TPI/3
does not allow you to alter the Brightness setting through the firmware and only shows the color
palette with
48
• BARGRAPH DISPLAY sets the bargraph as a vertical indicator for external devices.
Indicator levels must be defined in the programming language.
• BARGRAPH ACTIVE sets the bargraph as a vertical controller for external devices.
Indicator levels must be defined in the programming language. When a control level is set
on the horizontal bargraph, control data is sent to the Controller to control an external
device.
• BARGRAPH CENTERING sets the bargraph as a vertical controller with a default control
level. Levels must be defined in the programming language. When a control level change is
sent to the Controller, the external device changes accordingly until the control data input
stops. Then the control level on the horizontal bargraph returns to the default position and
the external device returns to a default control position.
• SLIDER DISPLAY sets the slider as a horizontal status indicator for external devices. Levels
must be defined in the programming language.
• SLIDER ACTIVE sets the slider as a controller for external devices. Control levels must be
defined in the programming language. When a control level is set on the horizontal
bargraph, data is sent to the Controller to control an external device.
• SLIDER CENTERING sets the slider as a horizontal controller with a default control level.
Control levels must be defined in the programming language. When a control level change
is sent to the Controller, the external device changes accordingly until the control data input
stops. Then the control level on the bargraph returns to the default position and the external
device returns to its default control position.
• BATTERY VOLTAGE sets the button to show the voltage level of the battery (if equipped).
• STRING opens the keyboard where you enter the data string to be sent to the Controller via
AXlink, RS-232, or RF communications. The data string appears in the STRING button.
Press ABORT to close the menu and exit without saving changes.
and buttons are disabled for this page. Black/White touch panels show
ABORT
button on this page.
TRANSPARENT
G3 Firmware Design and Reference