Table of Contents
Advertisement
Designing Touch Panel Pages
!
!
External CP4/A PushButtons
The functionality of these external pushbuttons is like those of other touch panels. The assignments
for these pushbuttons include Device/Channel numbers, Flip to Page options, and a string/macro
option. The properties for these buttons is set from the
in touch panel Edit mode. Refer to the G3 Firmware Design and Reference instruction manual for
more information on working with the firmware.
Setting the pushbutton LED illumination
The external pushbuttons LEDs are backlit via the illumination buttons on the Sensor Setup page of
the touch panel. The user can choose from five different illumination modes from a combination of
the three lower buttons on the Adjust Sensors page:
. Refer to page 18 through page 20 for more information on these modes.
AUTO
To activate the Button LED Illumination modes:
1. Press
2. Press the combination of the three illumination buttons that correspond to the method of
desired illumination.
The above mentioned illumination modes are also set through the use of AXlink Send_Commands.
CP4/A Feature Components
CP4/A Light Sensor
The CP4/A is equipped with a photo-sensitive sensor that gives the panel the ability to
automatically switch the brightness of the display's backlight between two settings: Normal Room
(NRM) and Dim-Room (DRM). The panel's backlight is the amount of light emanating from the
buttons and LCD display.
!
!
CP4/A Passive Infrared Sensor
The on-board infrared sensor provides motion detection that either "wakes-up" the CP4/A (Infrared
Wake) or sends an I/O signal to the Central Controller (Infrared Push/Release). This sensor is
mostly used for the illumination/non-illumination of the LCD, external backlit pushbuttons, and use
in the Push/Release control of room lights. The Adjust Sensors page displays a level indicator and
buttons that allow the user to change the following PIR settings: Infrared Wake, Infrared Push/
Release, Activation threshold.
22
MICROPHONE DEVICE #
number from 1 -4 into the on-screen Keypad and press ENTER when done.
MICROPHONE LEVEL #
of 1 - 8 into the on-screen Keypad and press ENTER when done.
from the Setup page.
ADJUST SENSORS
Normal-Room mode is equal to the brightness of the backlight directly selectable from
the
button in the Setup page.
SET BRIGHTNESS
Dim-Room mode allows the user to directly select the brightness value of the backlight
from the Sensors Setup page >
assigns a device number to the microphone. Enter a device
assigns a level number to the microphone. Enter a level value
>
EDIT
BUTTON
,
,
ON
OFF
PIR AUTO
button.
ADJUST SENSORS
>
menu while
PROPERTIES
,
, and
LS AUTO
PIR/LS
G3 Firmware Design and Reference
Advertisement
Table of Contents
