Table of Contents
Advertisement
4. Choose from any of these buttons and sliders to alter and set the properties for the speakers, IR
receiver, and microphone (FIG. 8 on page 21).
FIG. 8 Adjust Sensors page
!
!
!
!
!
G3 Firmware Design and Reference
allows the user to adjust the effective speaker volume. The panel
SPEAKER VOLUME
consists of an up button (UP), a down button (DN), and a current setting indicator (range
is between 0 and 32). The Speaker Volume up and down buttons adjust the Speaker
Volume. A zero value will mute the speaker. An adjustment to the speaker volume is also
achieved through the use of the SVOL AXlink Send_Command.
MICROPHONE ADJUSTMENT
volume. The panel consists of an up button (UP), a down button (DN), and a current
setting indicator (range is between 0 and 32). The Microphone Adjustment up and down
buttons adjust the Microphone Volume. A zero value will mute the microphone. An
adjustment to the speaker volume is also achieved through the use of the MVOL AXlink
Send_Command.
assigns a device number to the speaker. Enter a device number
SPEAKER DEVICE #
from 1 -4 into the on-screen Keypad and press ENTER when done.
assigns a level number to the speaker. Enter a level value of
SPEAKER LEVEL #
1 - 8 into the on-screen Keypad and press ENTER when done.
allows a user to enable/disable the IR feature. This toggles the
IR CODES DEVICE #
selection such that activating the button enables the IR Codes Device feature and
de-activating ("reverse video") disables the IR Codes Device feature.
The device number (n) displayed on the IR Codes Device button is one greater than the
number shown on the device used button on the protected setup page. This device number
is then added to the device base shown on the audio and IR Device Setup page and is used
when the IR codes are received and sent to the Master.
Example: If device base equals 128, device used equals four, and the IR Codes
!
Device feature is toggled On, then the IR Codes Device button will show five and the
IR device will be 132. When the IR Codes Device button is toggled off the IR Codes
Device will indicate zero.
allows the user to adjust the effective microphone
Designing Touch Panel Pages
21
Advertisement
Table of Contents
