Table of Contents
Advertisement
Editor and Setup Reference
Incoming Video Resolutions and Refresh Rates for the AXB-TPI/3
Name
VGA
SVGA
XGA
!
Any time you change the input resolution or refresh rate of the incoming computer
video, select the SET TO DEFAULT button and make the necessary adjustments.
!
!
!
!
Without RGB support, the RGB Setup page displays a
Protected button types
This feature sets the button as a Protected button. The button type
options appear in the Button Properties page. Protected buttons are similar to General buttons,
except they require the user to enter a password to flip to the specified destination page. Pressing a
Protected button opens the Keypad. Use the Keypad to enter the correct password. If the correct
password is entered, the page flips to the specified destination page. If the correct password is not
entered, no page flip occurs.
To set the Page Password, open the Protected Setup page, and press
password (up to 5 digits) into the keypad and press
Sensor Setup button types
This feature is ONLY AVAILABLE ON THE CP4 and sets the button as a Sensor Setup page
access button. The button type
button (associated with this option) is activated, the CP4 touch panel opens the Sensor Setup page
where the user can configure the Light and Motion Sensors to work in union with the button and
54
Resolution
640 x 480
800 x 600
1024 x 768
VGA/RGB X.XX displays the firmware version of the RGB card.
SET TO DEFAULT resets the RGB Setup page to factory default settings.
SHARPNESS ON / SHARPNESS OFF sets the touch panel to display the composite
video signal adjusted with/without sharpness (this button is not on the AXB-TPI/3).
ANALOG SYNC / TTL SYNC sets the touch panel's VGA synchronization analog from
analog to TTL (this button is not on the AXB-TPI/3).
SYNCS 75 OHMS / SYNCS 330 OHMS sets the touch panel's VGA synchronization
impedance from 75 ohms to 330 ohms (this button is not on the AXB-TPI/3).
S
ENSOR
Supported vertical refresh rates
• 60 Hz
• 72 Hz
• 75 Hz
• 85 Hz
• 52 Hz
• 60 Hz
• 72 Hz
• 75 Hz
• 60 Hz
• 70 Hz
• 75 Hz
• 85 Hz
NO RGB HW
to set the Page Password.
ENTER
appears in the Button Properties page. When the
S
ETUP
button.
and associated
PROTECTED
. Enter the
PAGE PASSWORD
G3 Firmware Design and Reference
Advertisement
Table of Contents
