Vertical Bargraph Button Types - AMX G3 Firmware Instruction Manual

For touch panel design and reference

Hide thumbs Also See for G3 Firmware:

Table of Contents

Editor and Setup Reference

FIG. 26 BUTTON OPTION menu - Joystick button

Vertical bargraph button types

This feature sets the button to a vertical bargraph or slider. New Send_Commands allow joystick

coordinates to originate from a different corner. Select VERTICAL BARGRAPH from the Button

Type menu to set the selected button to Vertical Bargraph. The button type VERTICAL

BARGRAPH and associated options appear in the Button Properties page as shown in FIG. 27.

FIG. 27 Button Properties page - Vertical Bargraph

• JOYSTICK NON-CENTER sets the button to a four-quadrant joystick with a control stick.

When you move the control stick, the touch panel sends data to the Central Controller and

to the external device to perform a pre-programmed operation. When you remove your

finger from the screen, the control stick and external device stay in that position.

• JOYSTICK CENTER sets the button to a four-quadrant joystick with a control stick located in

the center. When you move the control stick, the touch panel sends data to the Central

Controller and to the external device to perform a pre-programmed operation. When you

remove your finger from the screen, the control stick returns to the center of the button and

the external device returns to its default position.

• CROSSHAIR NON-CENTER sets the button to a four-quadrant crosshair with a control stick

located off-center. When you move the control stick, the touch panel sends data to the

Central Controller and to the external device to perform a pre-programmed operation. When

you remove your finger from the screen, the control stick and external device stay in that

position.

• CROSSHAIR CENTER sets the button to a four-quadrant cross-hair with a control stick

located in the center. When you move the control stick, the touch panel sends data to the

Central Controller and to the external device to perform a pre-programmed operation. When

you remove your finger from the screen, the control stick returns to the center of the button

and the external device returns to its default position.

BUTTON OPTIONS opens the BUTTON OPTION menu (FIG. 28) where you set the

button type. Press ABORT to close the menu and exit without saving changes.

G3 Firmware Design and Reference

Table of Contents