Editor and Setup Reference
Both the Network Eff. XXX% and the Device Eff. XXX% are the best indicators of
communication.
!
The SMT-PK(M) page provides read-only information about the SmartPack.
is the only changed setting. The SmartPack page shows the following information:
30
• Battery Voltage XX.X shows the voltage level of the lead-acid rechargeable battery in the
WAV-PK(M).
• RSSI XXX% shows the strength of the AXR-WAVES signal received by the touch panel. The
signal strength fluctuates between 0% and 100%, as shown by a horizontal gauge moving from
left to right.
• Group ID shows the GROUP ID number on the touch panel used to communicate with the
wireless AXR-WAVES with the same group ID number. The group ID range is 0 - 15. The group
ID setting overrides the DIP switch setting on the WAV-PK(M).
The GROUP ID number can be set from within the Wireless Settings page in the Protected
Setup page.
• Module Version vX.XX shows the firmware version installed in the WAV-PK(M).
• Fully Charged/Not Charging/Charging: Fully Charged appears when the battery, in the
WAV-PK(M), is fully charged. Not Charging appears when the lead-acid battery is not charging.
Charging appears when the lead-acid battery is charging. The shaded area is a horizontal
gauge moving from left to right as the battery voltage level increases.
• Network Eff. XXX% shows the communication efficiency of bi-directional RF transmissions
between the touch panel and AXR-WAVES. The efficiency percentage (0-100%) is determined
by the number of retries required to complete a panel operation.
• Device Range shows the device range that your server can recognize. Devices outside the
range will not be recognized.
• Server Devices XXX shows the group address for the AXR-WAVES communicating with the
touch panel.
• Server Version shows the firmware version of the AXR-WAVES.
• Supply Voltage vX.XX shows the voltage level of the external power supply (optional)
connected to the WAV-PK(M).
• Device Eff. XXX% shows the strength of the AXR-WAVES signal received by the touch panel.
The shaded area in the horizontal gauge moves from left to right as the RF signal intensity
increases. The shaded area fluctuates between 0% and 100%.
WIRELESS STATUS (optional SMT-PK and SMT-PKM) appears on the Setup page
when an either an optional SmartPack is connected to the touch panel or a VPT series
ViewPoint touch panel with one-way IR or RF transmission is used. Press the
button to open the page shown in FIG. 14.
STATUS
WIRELESS
SLEEP TIMEOUT
G3 Firmware Design and Reference