Figure 40-4 Menu 27.1.1: Ipsec Setup; Table 40-2 Menu 27.1.1: Ipsec Setup - ZyXEL Communications ZyWALL 10W User Manual

ZyWALL Series Internet Security Gateway
You must also configure menu 27.1.1.1 or menu 27.1.1.2 to fully configure and use
FIELD
Index This is the VPN rule index number you selected in the previous menu.
Name Enter a unique identification name for this VPN rule. The name may be up
to 32 characters long but only 10 characters will be displayed in Menu
27.1 - IPSec Summary.
Active Press [SPACE BAR] to choose either Yes or No. Choose Yes and press
[ENTER] to activate the VPN tunnel. This field determines whether a VPN
rule is applied before a packet leaves the firewall.
Keep Alive Press [SPACE BAR] to choose either Yes or No. Choose Yes and press
[ENTER] to have the ZyWALL automatically re-initiate the SA after the SA
lifetime times out, even if there is no traffic. The remote IPSec router must
also have keep alive enabled in order for this feature to work.
40-6
Menu 27.1.1 – IPSec Setup
Index= 1 Name= Taiwan
Active= Yes Keep Alive= No
Local ID type
My IP Addr= 0.0.0.0
Peer ID type
Secure Gateway Address= zw50test.zyxel.com.tw
Protocol= 0
Local: Addr Type= SINGLE
IP Addr Start= 1.1.1.1
Port Start= 0
Remote: Addr Type= SUBNET
IP Addr Start= 4.4.4.4
Port Start= 0
Enable Replay Detection = No
Key Management= IKE
Edit Key Management Setup= No
Press ENTER to Confirm or ESC to Cancel:

Figure 40-4 Menu 27.1.1: IPSec Setup

Table 40-2 Menu 27.1.1: IPSec Setup

DESCRIPTION
NAT Traversal= No
Content:
Content:
a VPN.
End= N/A
End= N/A
End= 255.255.0.0
End= N/A
VPN/IPSec Setup
EXAMPLE
1
Taiwan
Yes
No