Figure 43-4 Menu 27.1.1 Ipsec Setup; Table 43-2 Menu 27.1.1 Ipsec Setup - ZyXEL Communications Prestige 653HWI series User Manual

Prestige 653HWI Series User's Guide
Index= 1
Active= Yes
Local ID type
My IP Addr= 0.0.0.0
Peer ID type
Secure Gateway Address= zw50test.zyxel.com.tw
Protocol= 0
Local:
Remote:
Enable Replay Detection = No
Key Management= IKE
Edit Key Management Setup= No
The following table describes the fields in this menu.
FIELD
Index This is the VPN rule index number you selected in the previous menu.
Name Enter a unique identification name for this VPN rule. The name may be up
to 32 characters long but only 10 characters will be displayed in Menu
27.1 - IPSec Summary.
Active Press [SPACE BAR] to choose either Yes or No. Choose Yes and press
[ENTER] to activate the VPN tunnel. This field determines whether a VPN
rule is applied before a packet leaves the firewall.
Keep Alive Press [SPACE BAR] to choose either Yes or No. Choose Yes and press
[ENTER] to have the Prestige automatically re-initiate the SA after the SA
lifetime times out, even if there is no traffic. The remote IPSec router must
also have keep alive enabled in order for this feature to work.
Local ID type Press [SPACE BAR] to choose IP, DNS, or E-mail and press [ENTER].
Select IP to identify this Prestige by its IP address.
Select DNS to identify this Prestige by a domain name.
Select E-mail to identify this Prestige by an e-mail address.
43-6
Menu 27.1.1 – IPSec Setup
Name= Taiwan
Keep Alive= No
Content:
Content:
Addr Type= SINGLE
IP Addr Start= 1.1.1.1
Port Start= 0
Addr Type= SUBNET
IP Addr Start= 4.4.4.4
Port Start= 0
Press ENTER to Confirm or ESC to Cancel:

Figure 43-4 Menu 27.1.1 IPSec Setup

Table 43-2 Menu 27.1.1 IPSec Setup

DESCRIPTION
End/Subnet Mask= N/A
End= N/A
End/Subnet Mask= 255.255.0.0
End= N/A
EXAMPLE
1
Taiwan
Yes
No
VPN/IPSec Setup