ZyWALL Series Internet Security Gateway
LABEL
Server IP
Enter the inside IP address of the server here.
Address
Apply
Click Apply to save your changes back to the ZyWALL.
Reset
Click Reset to begin configuring this screen afresh.
9.5
Configuring Address Mapping
Ordering your rules is important because the ZyWALL applies the rules in the order that you specify. When a
rule matches the current packet, the ZyWALL takes the corresponding action and the remaining rules are
ignored. If there are any empty rules before your new configured rule, your configured rule will be pushed up
by that number of empty rules. For example, if you have already configured rules 1 to 6 in your current set
and now you configure rule number 9. In the set summary screen, the new rule will be rule 7, not 9. Now if
you delete rule 4, rules 5 to 7 will be pushed up by 1 rule, so old rules 5, 6 and 7 become new rules 4, 5 and
6.
To change your ZyWALL's Address Mapping settings, click SUA/NAT, then the Address Mapping tab.
The screen appears as shown.
9-10
Table 9-5 SUA Server
DESCRIPTION
Figure 9-5 Address Mapping
NAT Screens