Table of Contents
Advertisement
4
Maintenance
4.3
Fuse Replacement
The 2010A Analysis Unit requires two 5 x 20 mm, 1.6 A, T type
(Slow Blow) fuses. The fuses are located inside the explosion proof housing
on the Electrical Connector Panel, as shown in Figure 4-2. To replace a fuse:
1. Disconnect the Unit from its power source.
2. Place a small screwdriver in the notch in the fuse holder cap,
push in, and rotate 1/4 turn. The cap will pop out a few
millimeters. Pull out the fuse holder cap and fuse, as shown in
Figure 4-2.
Figure 4-2: Removing Fuse Cap and Fuse from Holder
4-2: Part II
Figure 4-1: Major Components
Teledyne Analytical Instruments
Model 2010A
Advertisement
Chapters
Table of Contents
