Teledyne 2010A Operating Instructions Manual page 24

3 Installation Model 2010A
mounting, one or two 2010A series analyzers are flush-panel mounted on
the rack panel. See Figure 3-1b for dimensions of the mounting panel.
HHinge
LLatch
Figure 3-a: Front Panel of the Model 00A
Figure 3-b: Single and Dual 9" Rack Mounts
All operator controls are mounted on the front panel, which is hinged
on the left edge and doubles as the door that provides access to the sensor
inside the instrument. The door is spring loaded and will swing open when
the button in the center of the latch (upper right corner) is pressed all the
way in with a narrow gauge tool (less than 0.18 inch wide), such as a small
hex wrench or screwdriver Allow clearance for the door to open in a 90-de-
gree arc radius of 7.62 inches. See Figure 3-2.
H
3- Part I
Teledyne Analytical Instruments