Teledyne 2010A Operating Instructions Manual page 85

Thermal Conductivity Analyzer
• Power In
CAUTION: Check the position of the Voltage Selector switch
• Voltage Selector Power input selector switch for electric heater.
• Fuses
• Solenoid Valves Terminals that provide all electrical intercon-
• Sensor Signal
Figure 1-2: Electrical Connector/Control Panel
Power input terminals for electric heater.
Requires 110 or 220 V ac, depending on
position of the Voltage Selector switch. Use
50/60 Hz.
BEFORE applying power to the Power Input termi-
nals.
Adjusts input requirement for 110 or
220 V ac, depending on available source
voltage. Use 50/60 Hz.
1.6 A, 250 V, T type, European size
5 × 20 mm fuses. Fuse 2 is on the neutral side
of the line. Fuse 1 is on the hot side of the
line.
nections from the Control Unit to the gas
control valves.
Terminals that provide connections from the
T/C sensor to the Control Unit.
Teledyne Analytical Instruments
Part II: Analysis Unit
Part II: 1-3